FPGA Marketing — Your Online Store for Development Boards, Microcontrollers & Accessories
FPGA Marketing
Showing 81–96 of 114 results
Connect a four-contact headset cable to a prototype. Switched left and right contacts let the circuit detect plug insertion.
Add directional input to a handheld controller or menu. Pressing the thumbstick activates a separate select button.
Build a soldered prototype on a 2 × 8 cm board with isolated holes. The pack contains three boards of the same size.
Build a soldered prototype on a 3 × 7 cm board with isolated holes. The pack contains three boards of the same size.
Build a soldered prototype on a 4 × 6 cm board with isolated holes. The pack contains three boards of the same size.
Build a soldered prototype on a 5 × 7 cm board with isolated holes. The pack contains three boards of the same size.
Build a soldered prototype on a 6 × 8 cm board with isolated holes. The 2 mm pitch accommodates closely spaced parts.
Add Micro-B USB power or data to a prototype. All five connector pins are available for wiring.
Add a Mini-B connection to a USB-capable microcontroller or a 5 V project. All five connector pins are accessible.
Give a USB peripheral a reversible USB-C connection. The onboard CC resistors configure the connector for use on the device side.
Build a custom cable harness around an inline USB-C socket. Both rows of connector contacts are accessible.
Detect nearby objects and measure ambient light with one sensor. The short-range detector is suitable for sensing a hand near a control panel.
Add external flash for firmware or application resources. This DIP breakout provides 16 MB through a Quad SPI interface.
Add external flash for firmware or application resources. This DIP breakout provides 2 MB through a Quad SPI interface.
Add external flash for firmware or application resources. This DIP breakout provides 8 MB through a Quad SPI interface.
Add a wired Ethernet connection to an embedded project. The host communicates with the WIZ5500 through SPI and a chip-select line.