Description
Arty Z7-20: APSoC Zynq-7000 Development Board for Makers and Hobbyists
Digilent recommends the Arty Z7-20 with SDSoC voucher for those interested in video processing applications. Vivado Design Suite voucher not included – Vivado Design Suite Edition is available for free download (Vivado WebPACK).
- Manufacturer: Digilent
- Manufacturer p/n: 410-346-20
- HTS code: 8473.30.1180
The Arty Z7 is a ready-to-use development platform designed around the Zynq-7000™ All Programmable System-on-Chip (AP SoC) from Xilinx. The Zynq-7000 architecture tightly integrates a dual-core, 650 MHz ARM Cortex-A9 processor with Xilinx 7-series Field Programmable Gate Array (FPGA) logic. This pairing grants the ability to surround a powerful processor with a unique set of software defined peripherals and controllers tailored by you for whatever application is being conquered. The design process is very straightforward and provides a systematic path between defining your custom peripheral set and bringing its functionality up to a Linux OS running on the processor. Digilent provides a number of materials and resources for the Arty Z7 that will get you up and running with this process quickly, see below.
Features
- 1 MSPS On-chip ADC: Yes
- Processor: Dual ARM Cortex A9
- Look-up Tables (LUTs): 53,200
- Flip-Flops: 106,400
- Block RAM: 630 KB
- Clock Management Tiles: 4
- Available Shield I/O: 49
Specifications
ZYNQ Processor
- 650MHz dual-core Cortex-A9 processor
- DDR3 memory controller with 8 DMA channels and 4 High Performance AXI3 Slave ports
- High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO
- Low-bandwidth peripheral controller: SPI, UART, CAN, I2C
- Programmable from JTAG, Quad-SPI flash, and microSD card (Micro USB cable not included).
- Programmable logic equivalent to Artix-7 FPGA
Memory
- 512MB DDR3 with 16-bit bus @ 1050Mbps
- 16MB Quad-SPI Flash with factory programmed 48-bit globally unique EUI-48/64™ compatible identifier
- microSD slot
Power
- Powered from USB or any 7V-15V external power source
USB and Ethernet
- Gigabit Ethernet PHY
- USB-JTAG Programming circuitry
- USB-UART bridge
- USB OTG PHY (supports host only)
Audio and Video
- HDMI sink port (input)
- HDMI source port (output)
- PWM driven mono audio output with 3.5mm jack
Switches, Push-buttons, and LEDs
- 4 push-buttons
- 2 slide switches
- 4 LEDs
- 2 RGB LEDs
Expansion Connector
- Two standard Pmod ports
- 16 Total FPGA I/O
Arduino/chipKIT Shield connector
- Up to 49 Total FPGA I/O (see table above)
- 6 Single-ended 0-3.3V Analog inputs to XADC
- 4 Differential 0-1.0V Analog inputs to XADC
Resources & Downloads
- Reference Manual/datasheet (off-site)
- Resource Center (off-site)






Reviews
There are no reviews yet.